Push your spark plug into the boot and make sure the top button goes into the spring. If the spring is not straight, take a small screwdriver and square it up. Be careful and do not puncture or tear the boot. 5. now the fun part, Bend the tabs over past 90 degrees on the steel shell. Use a flat-nosed pair of pliers. That is the distributor cap, which would also be a good idea to replace if you have any question about it's age. To access the spark plugs you will need to follow each of the wires that comes out of the top of the distributor cap. Pull each connector out of the engine, the piece that those boots connect to are the spark plugs. Figure 5 To remove the plugs use a 13/16 spark plug socket (it does not need to be thin walled) along with an extension. Place the socket over the plug and slowly rotate it until it seats over the rubber in the socket and the base of the plug (red arrow). Step 1 – Check for spark. If no spark is present at the end of the spark plug wire, the air/fuel mixture cannot ignite. To test for spark: Remove your spark plug wires from the spark plugs. Insert a spark tester into the wire and attach the tester to ground. Remove the fuel pump fuse. This vide will show you how to fix a broken spark plug wire that has pulled out of the spark plug boot on your lawn mower.DisclaimerOur videos are for entert TAY. Check Vehicle Fit. Spark Plug Wire Set Straight Boot; 10.625 Inch Length; Blue. 90 Day Limited Warranty. Color: Blue. Core Material: Spiral. The spark plug wires on your Chevy Silverado carry the voltage from the distributor or coils to the individual spark plugs. Diameter (mm): 8mm. Core Material: Fiberglass. Noise Suppression: Yes. 1. 2. 3. Last. Spark plug wires on your GMC Sierra send the voltage from the distributor cap and ignition coil to the spark plugs for ignition. Spark plug wires are typically made up of a conductive core, insulation to prevent arcing, and boots on both ends to connect to the Step 1: Safely Disconnect Both Ends of the Spark Plug Wire. Before proceeding, ensure the engine is off and cool to the touch. Slowly and carefully disconnect both ends of the spark plug wire you wish to test. One end is connected to the spark plug, and the other to the ignition coil or distributor. lGe6v.

how to connect spark plug wires